Razer Blade 16 (2024) stuck on the Razer logo after a failed BIOS update
This Razer Blade 16 (2024, model RZ09-0510) no longer started after a BIOS update. The Razer logo appeared on the screen, but Windows never loaded.
What does this screen mean?
This is the normal start-up screen of a Razer Blade: the Razer logo with three lines in the top left corner.
Press <F12> for Boot Menu: choose which device the laptop starts from, for example a USB stick.
Press <F1/DEL> for BIOS Setup: open the BIOS settings.
Press <F9> for Recovery Menu: start Razer's factory recovery. Note: this erases all data on the laptop.
Normally this screen shows for a few seconds and then Windows starts. So the laptop has power and the BIOS has begun starting up. If the screen stays, the laptop does not get past this point. On Razer's forums, owners of several Blade models report exactly this screen after a BIOS update.
What can you check yourself?
Right after switching on, press F1 or DEL a few times.
Does the BIOS menu open? Then the BIOS still works and the cause is usually Windows or the SSD. Razer's own steps or a reinstall can help.
Does nothing happen, even with an external USB keyboard, and does the logo stay? Then the laptop is stuck in the BIOS itself. Reinstalling Windows or replacing the SSD will not fix that. The BIOS chip has to be read and repaired outside the laptop.
The cause and our repair
We removed the BIOS chip (Winbond W25R256JV, 32 MB) from the motherboard and read it with an external programmer. The analysis showed that the BIOS itself was not damaged: version 1.03 was still complete and correct. The update had failed, but the laptop had never cleared the flag saying an update was waiting. So at every start it kept waiting for an update that was no longer there.
Instead of replacing the whole BIOS, we removed only that leftover of the failed update: four bytes in the settings memory of the chip. We then reprogrammed the chip, verified it and soldered it back onto the motherboard.
The laptop starts normally into Windows again. The data, the settings and the Windows installation all stayed intact. No reinstall was needed.




